maximus arcade locks up on rescan of media folder

The Vista drivers weren't needed as 7 has them already, obviously, and performance is even better than Vista's score already. with no 7 drivers nor none being proposed. ATI Redeon has 7 drivers up so I tried the earlier ones, as the 9.4 gave some problems on Vista and XP before. So far so good, and now I got down to what I dreaded - installing mobo, video card and sound card drivers. The first reboots were smooth and fairly quick. It went smooth and quickly! Luckily 7 recognized and readied my LAN and I went to the update page first and started browsing while they downloaded. I pulled my drive, installed a new one, and installed the 32bit RC. A Vista install doesn't get confused like this W7 shouldn't either.

This is just wrong, is a bug, and should be fixed. The issue is that if, for example, I have dual monitors configured on a running Vista system and then install W7, during the installation the setup confuses the two monitors and makes the 'primary' monitor (the BIOS boot monitor, and the #1 monitor in Vista/XP) number 2. You think instead that the install has failed. The problem is, if you happen to have your second monitor turned off while you install, at some point you'll never know that your installation is now proceeding on the 'other' monitor. I am well aware there are any number of workarounds after installation. You can configure which Monitor or Monitors you would like to display. very frustrating Right click on the Deskstop. If one of your Monitors a Standard LCD and the other is a WideScreen then that is where the final stages of the installation will wind up. WideScreen Monitors are Native to Windows 7 RC 7100. The entire install should display on the BIOS boot monitor, I should think. The fact that some of the install output displays on the secondary monitor is a problem. I finished the setup there, and then set my main monitor to be primary and now all is well. It first seemed as though the install hung - the primary simply showed a black screen even though it had been active thrtought the install. I turned on the secondary, and there was all the final install dialog display. However, during the last phase of the install of RC1 (this also occured with the first beta), the final output and startup of RC1 occurred on the secondary (!) monitor. I have set up a dual boot system with Vista and W7 and Vista runs just fine on the primary, and I can turn on the secondary at will. My BIOS boots to the 'primary' monitor, and during the install of RC1, most of the dialog occurred on this monitor. I have a dual monitor system - the video card is an NVidia GEForce 8800 with two DVI outputs.

Maximus arcade locks up on rescan of media folder